Newsgroups: comp.sys.transputer
From: YUENG@HARPO.TNSTATE.EDU
Subject: dos setup procedure for T400 in 486
Organization: UTexas Mail-to-News Gateway
Date: 21 Nov 1994 14:36:35 -0600
Message-ID: <01HJQT8GWK8E9AOEIO@HARPO.TNSTATE.EDU>

Hi

Thanks for everyone who responded to my earlier
post about manuels for a T800; I installed the
board now into a gateway 486 and it was actually
a T400. For now, I will be happy to see if
the board is working (saving the manuels for later)
... so I reinstall the software and changed the
autoexec.bat so that now it has IBOARDSIZE=#2000000;
however, most programs still hangs (no error message
like IBOARDSIZE undefined logic variable) so I
think sth else is not setup properly. Can someone
make some suggestions ? I've only done this
for a AT286 (1988) and have since switched to
workstations ...

Thanks ahead for helpful comments/feedback ..
this is a warm-up excercise before we get some
T9000 into the lab ...

GEofF Yuen
TSU Center for Neural Engineering

