Newsgroups: comp.sys.transputer
From: d.r.smith@e-eng.uk.ac.hull (Dave Smith)
Subject: Building A TRAM
Organization: Hull University
Date: 25 Aug 1994 10:43:45 GMT
Message-ID: <33hsl1$lqb@wimbledon.dcs.hull.ac.uk>

HELP!

Two of us here have been trying to build a transputer based 
robot controller and we are having no luck whatsoever. We have
temporarily given up trying to get the whole board working while
we try and build an ultra-basic TRAM to make sure we have the basics 
okay.
What we have is a T225, with link 1 wired as in the Transputer Technical
Notes, BootFromROM low, and the rest of the pins as they should be according
to the data (as far as we know).
When we run a worm, either the B008 one or the TDS2 one, the T225 receives 
a packet on Link1In and sends an acknowledge, but that's it, finished. The
worm doesn't recognise it and nowt else happens.

If anyone out there in transputer land has any advice (or circuit diagrams)
then you would be saving two poor men a lot of heartache.

Thanks in advance

Dave Smith
Dave Moody


