Newsgroups: comp.sys.transputer
From: muenkel@daedalus.tnt.uni-hannover.de (Heiko Muenkel)
Subject: Problem with INMOS C Toolset debugger 
Organization: Universitaet Hannover, Theoretische Nachrichtentechnik
Date: Thu, 21 Jul 1994 16:01:20 GMT
Message-ID: <MUENKEL.94Jul21180120@daedalus.tnt.uni-hannover.de>

Hello,

I've the following problem:

I've written a program, that runs on 9 transputers (T800, T805). The 
program is written with the INMOS C Toolset. On every transputer is
only one process. After loading the program with the debugger on the
transputernet I've made a memory check with the debugger on all 9
transputers and everything seemed to be ok. After that I've set a break-
point in every process at the first possible place (at the open brace
of main). Then I've started the program. After visiting the first 
breakpoint I've run an additional memory check on the whole network.
The test of the first 3 tranputers is ok, but then the debugger hangs.
The same occured, if I'm only switching from one transputer to the other
after viewing the breakpoint.

Has anobody an idea about the reason of this or an idea to find the 
reason ?

I think, that my code could not be the reason of this behaviour, because
I've set a breakpoint at the first possible place in every process. What
do you think ?


Thanks in advance,

Heiko

PS: I've also tried to set the breakpoint at a later statement, with the 
    same results.
-- 
____________________________________________________________________________

Dipl.-Ing. Heiko Muenkel           Universitaet Hannover
				   Institut fuer 
				   Theoretische Nachrichtentechnik
				   und Informationsverarbeitung
muenkel@tnt.uni-hannover.de        Appelstrasse 9A
fax:    +49-511-762-5333           30167 Hannover
phone:  +49-511-762-5323           Germany
____________________________________________________________________________

