Newsgroups: comp.sys.transputer
From: ijg@oiiag.demon.co.uk (Ian Gillingham)
Subject: Re: FFT in Occam
Organization: Oxford Instruments - IAG
Date: Tue, 12 Jul 1994 13:47:26 +0000
Message-ID: <774020846snz@oiiag.demon.co.uk>

In article <west.12.00AA7B7D@emt.e-technik.tu-muenchen.de>
           west@emt.e-technik.tu-muenchen.de "Robert Westendorp" writes:

> I`m looking for a simple FFT algorithm written in Occam.
> It can be plain sequential.
> 
> Thanks a lot
> 
> Robert
> 

So are we, but we would prefer a bit of parallelism !

We will write our own if we can't find one.

Several years ago Perkin Elmer (Maxwell Road, Beaconsfield
U.K.) created an OCCAM FFT for one of their instruments. It
was capable of being run on a single T4 or a network of 5 T4s.

I am not sure how best to contact them - perhaps through their GMBH ?
-- 
=============================================================
Ian Gillingham                  Oxford Instruments
email: ijg@oiiag.demon.co.uk    Industrial Analysis Group
Tel  : +44 (0)235 532123        19/20 Nuffield Way
Fax  : +44 (0)235 535416        Abingdon
                                Oxon, UK    OX14 1TX
=============================================================

